Welcome to N2News FTA Files Forums

Module Installation Help Do this with power cord unplugged.

1) Remove 3 screws holding the cover on the box.
2) Remove rubber plug from UHF Remote Antenna hole
3) Insert board into unit with threaded cable connector portion through UHF Remote Hole
4) Attach board with screw supplied.
5) Attach board with washer and nut on threaded cable connection
6) Attach black ended cable to main board (it's obvious where and it's keyed so you can't go wrong)
7) Attach other end of black ended cable to board (keyed..can't go wrong unless you're a gorilla)
8) Attach white cable that is in box to board (also keyed).
9) Replace cover on box
10) Attach loop though cable to board and IF Out on box

You're done.

NOTE: The white cable that is already inside the box with this first shipment may not be there with future shipments. I think they just left it in the box when they removed the modules from this first production run. That would explain why there's an identical cable included with the module