Welcome to N2News FTA Files Forums

I loaded the new 151 bin, set up 110 and 119 , channel scanned now I get the channel guide but none of the channels are working, not even the ones that are currently listed as being up. Just get service not available.
Signal strength and quality is good as my viewsat ultras were all previously connected .

Any ideas???? I have not connected the internet cable as yet.

it has to be connected to the net at all times to work

thanks - I plugged it into one of the ports on my router - still have no channels - is there a step that I have missed???

try and reboot the whole sys

turned unit off from switch on back - rebooted -still no channels-just get the following message

Service not available
to change channels press up or down
I-ON / n-ON/ p-ON / Emul-OFF / SUNS Disconnected

are you runing a proxy?

You need to load the u43 file first. Then the 1.51. Unless you load the u43 first...this will not work.

ALL YOU HAVE TO DO IS HIT "THANKS" IF THIS HELPED.

TESTING : VS 9000HD, VS ULTRA, NFUSION SOLARIS

Where can I buy the IKS Slinger option solutions?

do not hijack threads. start a new thread.

Thanks for the help. I reloaded the u43 and then the 151, did the setup for 119 and 110, and I am still getting no channels and the same message.
One thing I notice if I check boot and s/w version its still says r3x 1.30, should it not say the latest version I just loaded? s/w says 1.51.
I am not using a proxy.