Welcome to N2News FTA Files Forums

go into menu and turn p/on to p/off

thanks - did that - still the same no channels and the same message appears - service not avaialable even though I am on channels that are supposed to work according to the latest list posted
I am curious as to why I cannot see the latest boot of 43. It still shows 1.30, even though the s/w shows 1.51 which was just loaded.

u43 is a factory file 1.30 is your boot file

ok thanks - anyway I still have no channels coming up -just the service not available message

if I have done this right
loaded the u43
loaded the 151
set up for 110 AND 119
did channel scan on both
the guide shows all the channels but none are working
internet cable connected and the green light is on on the connector at the back of the unit

Check the IP settings to make sure they are correct.

All information provided is purely speculation as I do not test. Use the provided information at you own risk.

Starrmann,
I am in the same boat as you I did all the upgrades and checked settings and versions, and still no channels...

" In the dark recess of your room, we are always watching, for only the Ghost sees what goes on behind close doors"

ok turn the nfusion off from the back then power cycle your modem by unplugingc and unhook the battery if it has one so that it can be fully rebooted now plug back up modem let it reboot completely then turn stb back on. once it is back on and has ebooted push the power button twice and it will reboot again and all should be well

still nothing... did all that was suggested..

" In the dark recess of your room, we are always watching, for only the Ghost sees what goes on behind close doors"

I have noticed that the red light on the front what usually was on in the past when connected is n't showing up, unless powered down. have been able to check iks connection and look for upgrade and it shows it is working..

" In the dark recess of your room, we are always watching, for only the Ghost sees what goes on behind close doors"

Thanks for the help. It makes this much easier.
I was just reading a previous post - it says to go to channel 342 and wait.
Well in a few minutes cahnnel 342 started to work.
Not all the channels that have been listed as working are though, only some.
Should I do a channel rescan now that some are working??????