hooked up ****, not getting ppv b3v and dish, for what I read channels are down, whats other people getting on there cnx mini?

Up and running, you need to get an IX-200 connect to internet download and install new files 3.48 and ****** file you should be up and running in minutes. I know it was down for a while a couple days ago but up now.

can you help me i have a cnx mini how do you preform a ix-200 internet connect and what do you need to do this

The IX-NET (IX-200) CNX ****** works on all supported CNX Receivers.
CNX ****** Setup Instructions

Upgrade your CNX Nano, Mini, Duo or Trio with the latest "Upgrade" file (Boot Loader).

After the upgrade goto Menu -> Accessory ->RS-232 Mode and select Type to ******.
(For CNX Nano 2 Only: Set RS-232 to Normal. Ignore steps 5 thru 7. On Step 8, You set your network settings up under Menu -> Installations -> Network)

Connect the CNX ****** to the RS-232 Serial Port.

Connect the Category 5 Patch cable to the CNX ******.

After about 10 seconds the CNX ****** will boot up complete and will activate the network settings. You should notice the ethernet turn on and light up your router or switch port.
Go to Menu -> System Information
On the very bottom line it should show the CNX ****** software version

If it shows the version it means connected but if it shows Unknown it means not connected.

When Connected go to USB Menu and select the DGL(cnx ****** upgrade file.).
A. It should start to upgrade the CNX ******.
B. After the upgrade please check the System Information in the Menu and make sure the upgraded version is the latest.

Go to Menu Accessory -> RS-232 Mode and select Network IP Setup.

Your CNX receiver will then read the ****** IP information and display it. If the IP information shows Auto or Maual it means the IP setup has been previously configured.

A. If it shows Not Used it means the setup has not yet been done. If your Category V patch cable is good and it appears there is no problem with the physical connection, please select Auto and Apply.
B. IF you dont see IP information after 20 to 30 seconds there is likely a problem with DHCP on your network or you may need to do a manual network setup.

When the network setup has been performed successfully, go to a *** or DN N3 encrypted channel and the CNX ****** will try to connect to the *** server.
Press OK
A. Many Dish and *** channels should be working for now. More channels will come very soon.
B. If no video/audio shows up on your CNX Nano it means that there is some sort of problem, which may include a problem with the seoftware and/or the server or your network connection failed.